MATLAB EMBEDDED IDE LINK 4 - FOR USE WITH TEXAS INSTRUMENTS CODE COMPOSER STUDIO Podręcznik Użytkownika Pobierz pdf (Strona 438)

100

101

Tar get Preferences

memory map for your processor. Both steps are essential for generating

code for any board that is custom or explicitly supported, such as the

C6711 DSK or the DM642 EVM .

Unlike most other blocks, you cannot open the bl ock dialog box until

you add the block to a model. When yo u open the block dialog, the block

attempts to connect to your processor. It cannot make the connection

when the block is in the library and returns an error message.

Note If you do not have Texas Instruments’ Code C ompose r Studio

software installed, you cannot open this block.

Generating Code from Model Subsystems

Real-Time Workshop software provides the ability to generate code

from a selected subsystem in a model. To generate code for custom

C2xxx, C5xxx, or C6xxx processor-based hardware from a subsystem,

the subsystem model must include a Target Preferences block.

Dialog

Box

This reference page section contains the following subsections:

• “Board Info Pane” on page 9-48

• “Memory Pane” on page 9-52

• “Physical M emory Options” on page 9-54

• “Sections P an e” on pa ge 9-58

• “DSP/BIOS Pane” on page 9-62

• “Perip herals P ane” on page 9-65

• “New Processor D ialog Box” on page 9 -107

9-46

1 2 ... 433 434 435 436 437 438 439 440 441 442 443 ... 574 575

Komentarze do niniejszej Instrukcji

Brak uwag

MATLAB EMBEDDED IDE LINK 4 - FOR USE WITH TEXAS INSTRUMENTS CODE COMPOSER STUDIO Podręcznik Użytkownika Strona 438

Komentarze do niniejszej Instrukcji