MATLAB EMBEDDED IDE LINK 4 - FOR USE WITH TEXAS INSTRUMENTS CODE COMPOSER STUDIO Podręcznik Użytkownika Pobierz pdf (Strona 101)

LF2407 eZdsp

3-59

and twice before at a distance of TQ/2. A majority decision is made from

the three points.

SBG — Sets the message resynchronization triggering. Options are

Only_falling_edges and Both_falling_and_rising_edges.

SJW — Sets the synchronization jump width, which determines how many

units of TQ a bit is allowed to be shortened or lengthened when

resynchronizing.

SelfTestMode — If True, sets the CAN module to loopback mode, where a

“dummy” acknowledge message is sent back without needing an

acknowledge bit.

TSEG1 — Sets the value of time segment 1, which, with TSEG2 and BRP,

determines the length of a bit on the CAN bus. TSEG1 must be greater

than TSEG2 and the Information Processing Time (IPT). The IPT is the

time needed to process one bit and corresponds to two TQ units.

TSEG1 = PROP_SEG + PHASE_SEG1. Valid values for TSEG1 are from

1 through 16.

TSEG2 — Sets the value of time segment 2 (PHASE_SEG2), which, with

TSEG1 and BRP, determines the length of a bit on the CAN bus. TSEG2

must be less than or equal to TSEG1 and greater than or equal to IPT.

Valid values for TSEG2 are from 1 through 8.

DSP Chip Label — DSP chip model. Select the DSP chip installed on your

target. The chip model is fixed for the LF2407 eZdsp. If you change the

chip model, an error will be generated in code generation.

The CAN bit timing is shown in the following illustration.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 111 112

Brak uwag

MATLAB EMBEDDED IDE LINK 4 - FOR USE WITH TEXAS INSTRUMENTS CODE COMPOSER STUDIO Podręcznik Użytkownika Strona 101