MATLAB EMBEDDED IDE LINK 4 - FOR USE WITH TEXAS INSTRUMENTS CODE COMPOSER STUDIO Podręcznik Użytkownika Pobierz pdf (Strona 8)

1 Getting Started

1-4

Refer to the documentation provided with your hardware for information on

setting up and testing your target board.

Note You do not need to change any jumpers from their factory defaults on

either the LF2407 or F2812 target board.

Software Requirements

MathWorks Software

For up-to-date information about other MathWorks software you need to use

the Embedded Target for the TI TMS320C2000 DSP Platform, refer to the

MathWorks Web site —

http://www.mathworks.com. Check the Product area

for the Embedded Target for the TI TMS320C2000 DSP Platform.

For information about the software required to use the MATLAB Link for Code

Composer Studio Development Tools, refer to the Products area of the

MathWorks Web site —

http://www.mathworks.com.

Texas Instruments Software

In addition to the required software from The MathWorks, Embedded Target

for the TI TMS320C2000 DSP Platform requires that you install the Texas

Instruments development tools and software listed in the following table.

Installing Code Composer Studio IDE Version 2.12 or 2.2 for the C28x series

installs the software shown.

Required TI Software for Targeting Your TI C2000 Hardware

Installed Product Additional Information

Assembler Creates object code (.obj) for C2000 boards from

assembly code

Compiler Compiles C code from the blocks in Simulink

models into object code (.

obj). As a byproduct of the

compilation process, you get assembly code (.

asm) as

well.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 111 112

Brak uwag

MATLAB EMBEDDED IDE LINK 4 - FOR USE WITH TEXAS INSTRUMENTS CODE COMPOSER STUDIO Podręcznik Użytkownika Strona 8